Brocade Network OS Command Reference v4.1.0 - Manual (Page 968)

930 Network OS Command Reference
53-1003115-01
show name-server detail
2
show name-server detail
Displays local name server (NS) information about devices connected to a switch.
Synopsis show name-server detail [rbridge-id rbridge-id]
Operands rbridge-id rbridge-id Specifies the RBridge ID of the switch for which the details about name
server entries are displayed.
Defaults If no RBridge ID is specified, detailed entries for all devices in the fabric are displayed.
Command Modes Privileged EXEC mode
Description Use this command to display detailed local name server (NS) information about devices connected
to a switch. The detail output contains the following information for each device:
PID Fibre Channel address of the device in 6-digit hexadecimal format.
Port Name Worldwide port name (WWPN) of the device.
Node Name Worldwide node name (WWNN) of the device.
SCR Indicates the State Change Registration of the device, which affects RSCN
behavior. The value can be one of the following:
0: No registration
1: Fabric detected RSCN
2: Port detected RSCN
3: Both Fabric and Port detected RSCN
NOTE
This information is only available for devices that are connected to the local RBridge on which
the command is executed.
FC4s Fibre Channel FC4 type of the device represented as an ASCII string.
PortSymb User defined name for this port (ASCII string).
Fabric Port Name Fabric port name (worldwide name format). This is the F_Port worldwide
name to which the N_Port connects.
Permanent Port Name
Physical Nx_Port worldwide name.
Device Type Type and role of the device, where the device type is either “Physical”,
“Virtual”, “NPIV”, or “iSCSI”. The role is either “Initiator”, “Target”, or
“Initiator + Target”. If the device role is not registered, the display indicates
“unknown”. If the device registers a type that is not one of the
aforementioned values, then the type is listed as “undefined”.
Interface Interface information for the port. For FCoE devices this information is
shown as: Fcoe vlan/rbridge-id/FCoE port
Physical Interface Physical interface information for the port. For FCoE devices this
information is shown as: Te rbridge-id/slot/port
Where Te = Ten gigabit Ethernet