Brocade Network OS Command Reference v4.1.0 - Manual (Page 186)

148 Network OS Command Reference
53-1003115-01
clock timezone
2
clock timezone
Sets the time zone based on region and longitudinal city.
Synopsis clock timezone region/city [rbridge-id {rbridge-Id | all}]
no clock timezone [rbridge-id rbridge-Id]
Operands region Specifies the region’s time zone.
city Specifies the city’s time zone.
rbridge-id Enables RBridge ID mode to support Logical chassis cluster mode on
individual nodes.
rbridge-id Specifies a unique identifier for a node.
all Specifies all identifiers for a node.
Defaults None
Command Modes Privileged EXEC mode
Description Sets the local clock time zone.
Usage Guidelines Regions include the following countries: Africa, America, Pacific, Europe, Antarctica, Asia, Australia,
Atlantic, Indian, and longitudinal city. For a complete listing of supported regions and cities, refer
to Appendix C in the Network OS Administrator’s Guide.
By default, all switches are in the Greenwich Mean Time (GMT) time zone. The no operand
removes the timezone setting for the local clock. When using the no operand, you do not need to
reference a timezone setting.
The no operand is not distributed across the cluster. The RBridge ID of the node should be used.
Network Time Protocol (NTP) commands must be configured on each individual switch.
The region name and city name must be separated by a slash (/).
After upgrading your switch to a new Network OS version, you might need to reset the time zone
information.
The rbridge-id operand is supported in VCS mode only.
Examples Standalone mode
To set the time zone to Pacific Standard Time in North America:
switch# clock timezone America/Los_Angeles
To remove the timezone setting:
switch# no clock timezone
Logical chassis cluster mode
To set the time zone to Pacific Standard Time in North America on all nodes in the cluster:
switch# clock timezone America/Los_Angeles rbridge-id all