Brocade Network OS Command Reference v4.1.0 - Manual (Page 371)

Network OS Command Reference 333
53-1003115-01
interface loopback
2
interface loopback
Configures a loopback interface.
Synopsis interface loopback port_number
no interface loopback port_number
Operands port_number Specifies the port number for the loopback interface. The range is 1
through 255.
Defaults None
Command Modes RBridge ID configuration mode (for VCS)
Global configuration mode (for standalone)
Description Use this command to configure a loopback interface. Loopback is a logical interface traditionally
used for stable routing operation.
Usage Guidelines Enter no interface loopback port_number to remove the specified loopback interface.
Example This example shows the steps needed to create a loopback interface with a port number of 25 for
RBridge ID 11. This example is for a VCS environment.
switch(config)# rbridge-id 11
switch(config-rbridge-id-11)# interface loopback 25
See Also interface, interface vlan