Qos dscp-traffic-class – Brocade Network OS Command Reference v4.1.0 User Manual

Page 615

Network OS Command Reference

577

53-1003115-01

qos dscp-traffic-class

Applies a defined DSCP-to-Traffic-Class map to an interface,

Synopsis

qos dscp-traffic-class name

no qos dscp-traffic-class

Operands

name

Name of DSCP-to-Traffic-Class map

Defaults

DSCP-to-Traffic-Class map is not enabled on the interface.

Command Modes

Interface subtype configuration mode

Description

Use this command to apply a QoS DSCP-to-Traffic-Class map defined by the qos map
dscp-traffic-class name command to a specific interface.

Usage Guidelines

Enter no qos dscp-traffic-class while in the interface mode to remove the DSCP-to-Traffic-Class
map from the interface.

Examples

To apply a configured DSCP-Traffic-Class map named test to a specific interface, enter
qos dscp-traffic-class name while in the interface configuration mode:

switch(config)# interface tengigabitethernet 16/2/2

switch(conf-if-te-16/2/2)# qos dscp-traffic-class test

To remove a configured DSCP-Traffic-Class map named test from a specific interface, enter no qos
dscp-traffic-class while in the interface configuration mode:

switch(config)# interface tengigabitethernet 16/2/2

switch(conf-if-te-16/2/2)# no qos dscp-traffic-class