Spanning-tree link-type – Brocade Network OS Command Reference v4.1.0 User Manual

Page 1282

1244

Network OS Command Reference

53-1003115-01

spanning-tree link-type

Enables and disables the rapid transition for the Spanning Tree Protocol (STP).

Synopsis

spanning-tree link-type [point-to-point | shared]

Operands

point-to-point

Enables rapid transition.

shared

Disables rapid transition.

Defaults

The spanning-tree link-type is set to point-to-point.

Command Modes

Interface subtype configuration mode

Description

Use this command to specify a link type for STP.

Usage Guidelines

This command overrides the default setting of the link type.

If xSTP is enabled over VCS, this command must be executed on all RBridge nodes.

Examples

To specify the link type as shared:

switch(config)# interface tengigabitethernet 0/1

switch(conf-if-te-0/0)# spanning-tree link-type shared