Brocade Network OS Command Reference v4.1.0 - Manual (Page 1094)

1056 Network OS Command Reference
53-1003115-01
show running-config interface tengigabitethernet
2
show running-config interface tengigabitethernet
Displays the status of 10-gigabit Ethernet interfaces.
Synopsis show running-config interface tengigabitethernet [rbridge-id/slot/port]
Operands rbridge-id Specifies a switch by the its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
Defaults Displays the configuration of all 10-gigabitEthernet interfaces on the local switch.
Command Modes Privileged EXEC mode
Description Use this command to display the configuration of 10-gigabit Ethernet interfaces.
Usage Guidelines None
Examples To display configuration information about all 10-gigabit Ethernet interfaces on a Brocade
VDX 6710 switch:
switch# show running-config interface tengigabitethernet
interface Ten Gigabit Ethernet 22/0/49
fabric isl enable
fabric trunk enable
no shutdown
!
interface Ten Gigabit Ethernet 22/0/50
fabric isl enable
fabric trunk enable
no shutdown
!
interface Ten Gigabit Ethernet 22/0/51
fabric isl enable
fabric trunk enable
no shutdown
!
interface Ten Gigabit Ethernet 22/0/52
fabric isl enable
fabric trunk enable
sflow enable
no shutdown
!
interface Ten Gigabit Ethernet 22/0/53
fabric isl enable
fabric trunk enable
sflow enable
shutdown
!
interface Ten Gigabit Ethernet 22/0/54
fabric isl enable
fabric trunk enable
See Also interface