Brocade Network OS Command Reference v4.1.0 - Manual (Page 230)

192 Network OS Command Reference
53-1003115-01
debug lldp dump
2
debug lldp dump
Dumps the LLDP debug information to the console.
Synopsis debug lldp dump {all | [interface tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port] [both]] | [detail [both | rx | tx]}
no debug lldp dump {all | interface tengigabitethernet slot/port}
Operands all Dumps all information to the console.
interface Use this parameter to specify the interface to be monitored.
tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the routing bridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
both Turns on debugging for both transmit and receive packets.
detail Turns on debugging with detailed information.
both Turns on detailed debugging for both transmit and receive packets.
rx Turns on detailed debugging for only received LLDP packets.
tx Turns on detailed debugging for only transmitted LLDP packets.
Defaults LLDP debugging is disabled.
Command Modes Privileged EXEC mode
Description Use this command to dump debugging information for Link Layer Discovery Protocol (LLDP) to the
console.
Usage Guidelines None
Examples Typical use of this command.
switch# debug lldp dump all
LLDP Interface Debug Information for Te 1/0/3
Admin Status: RX_TX
Associated Profile:
Link-level FCoE Priority: 0x08 (Configured: No)
Link-level iSCSI Priority: 0x10 (Configured: No)
Link Properties:
CEE Incapable
FCoE LLS not Ready
FCF-Forward Disabled