Brocade Network OS Command Reference v4.1.0 - Manual (Page 281)

Network OS Command Reference 243
53-1003115-01
dot1x timeout re-authperiod
2
dot1x timeout re-authperiod
Sets the 802.1X reauthorization-attempts interval.
Synopsis dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
Operands seconds Specifies the seconds between reauthorization attempts. Valid values
range from 1 through 4294967295 seconds.
Defaults 3600 seconds
Command Modes Interface subtype configuration mode
Description Use this command to set the number of seconds between reauthorization attempts on a specific
interface.
Usage Guidelines Enter no dot1x timeout re-authperiod to return to the default setting.
Examples To set 25 seconds as the amount of time between reauthorization attempts on a specific 1-gigabit
Ethernet interface:
switch(config)# interface gigabitethernet 190/0/9
switch(conf-if-gi-190/0/9)# dot1x timeout re-authperiod 25
To set the time between reauthorization attempts to the default value on a specific 40-gigabit
Ethernet interface:
switch(config)# interface fortygigabitethernet 180/0/5
switch(conf-if-fo-180/0/5)# no dot1x timeout re-authperiod
See Also interface, dot1x timeout server-timeout, dot1x timeout supp-timeout, dot1x timeout tx-period