Port-group – Brocade Network OS Command Reference v4.1.0 User Manual

Page 581

Network OS Command Reference

543

53-1003115-01

port-group

Enables port-group configuration mode for VDX 8770 Switch line cards that support the port-group
command. The mode is a prerequisite reserved for future options that will configure port groups
on supported Brocade VDX 8770 Switch line cards.

Synopsis

port-group rbridge-id/slot/port-group-id

Operands

rbridge-id

A unique identifier for the switch. Values are from 1 through 239. This is not
valid in standalone mode.

slot

Specifies a valid slot number.

port-group-id

A port group number specific to the Brocade VDX 8770 switch line cards
that support this command.

Defaults

None.

Command Modes

Hardware configuration mode

Description

Use this command to enter port-group configuration mode for a port group specific to a VDX 8770
line card that supports this configuration mode. When you launch the port-group command, the
system is placed in configuration mode for the port group. At this point, you can configure
performance or density mode for the port group.

Usage Guidelines

The port group identification number is specific for the line card that supports this configuration
mode. Refer to the Brocade 8770-4 Hardware Reference Manual or 8770-8 Hardware Reference
Manual “Overview” chapter for more information.

NOTE

This command is only supported on specific line cards installed on Brocade VDX 8770-4,
VDX 8770-8, and later switches.

Examples

To enable port-group configuration mode for port group 9 on a line card located in slot 3 on a
switch with RBridge ID 1:

switch(config-hardware)# port-group 1/3/9

switch(config-hardware-port-group-1/3/9)