Brocade Network OS Command Reference v4.1.0 - Manual (Page 1199)

Network OS Command Reference 1161
53-1003115-01
show sfp
2
show sfp
Displays the SFP breakout configurations.
Synopsis show sfp [linecard linecard [port port ]]
Operands linecard linecard Specifies line card information.
port port Specifies port information.
Defaults Displays the SFP breakout information using a line card. Port number is optional. If absent, all SFP
port configurations are shown.
Command Modes Privileged EXEC mode
Description Use this command to display the SFP configuration for the specified line cards. The speed column
shows the breakout speed in breakout mode, and the aggregate speed when not in breakout
mode.
Usage Guidelines This command is supported on the line cards.
Examples To display the SFP configuration on a line card:
switch# show sfp linecard 1
Port Type Breakout Speed
----------------------------------------------------------------------
1 SFP n/a 10G
2 QSFP 4x10G 10G
3 SFP n/a 40G
4 CSFP 10x10G 100G
switch# show sfp linecard 1 port 2
Port Type Breakout Speed
----------------------------------------------------------------------
2 QSFP 4X10G 10G
See Also clear support, copy support, show support, power-off linecard, power-on linecard,
show running-config hardware connector