Zoning enabled-configuration cfg-action cfg-save – Brocade Network OS Command Reference v4.1.0 User Manual

Page 1414

1376

Network OS Command Reference

53-1003115-01

zoning enabled-configuration cfg-action cfg-save

Saves the defined configuration to persist across reboots.

Synopsis

zoning enabled-configuration cfg-action cfg-save

Operands

None

Defaults

None

Command Modes

Global configuration mode

Description

Use this command to save the current zone configuration persistently. This command writes the
defined configuration and the name of the defined zone configuration to nonvolatile memory in all
switches in the VCS Fabric.

The saved configuration is automatically reloaded at power on. If a configuration was in effect at
the time it was saved, the same configuration is reinstalled with an automatic
zoning enabled-configuration cfg-name command.

The zoning enabled-configuration cfg-action cfg-save command validates the effective
configuration by performing the same tests as the zoning enabled-configuration cfg-name
command on enabling the configuration. If the tests fail, an error message is displayed and the
configuration is not saved.

This command commits the current transaction. Pending transactions are pushed to nonvolatile
memory. Any empty zones or empty configurations are deleted.

Usage Guidelines

This command is supported only in Brocade VCS Fabric mode. Zoning configuration data are
automatically distributed among all RBridges in the VCS Fabric. Standalone mode is not
supported.

This command can be entered on any RBridge in a Brocade VCS Fabric, but it is always executed
on the principal RBridge in fabric cluster mode. In logical chassis cluster mode, edits can be
performed only from the principal RBridge.

Examples

The following example saves the current zone configuration:

switch(config)# zoning enabled-configuration cfg-action cfg-save