Brocade Network OS Command Reference v4.1.0 - Manual (Page 612)

574 Network OS Command Reference
53-1003115-01
qos cos-traffic-class
2
qos cos-traffic-class
Applies a CoS-to-Traffic Class QoS map on an interface.
Synopsis qos cos-traffic-class name
no qos cos-traffic-class
Operands name Specifies the name of a previously created CoS-to-Traffic Class QoS map.
Only one CoS-to-Traffic Class QoS map can exist at a time. An existing
CoS-to-Traffic Class QoS map must be removed before a new one can be
applied.
Defaults No explicit CoS-to-Traffic Class QoS map is applied; the implicit behavior is to match the
IEEE 802.1Q recommendations for systems supporting 8 Traffic Classes.
Command Modes Interface subconfiguration mode (fo, gi, port-channel, te)
Description Use this command to apply a CoS-to-Traffic Class QoS map to a specific interface.
Usage Guidelines This command is not available when the interface is in the CEE provisioning mode.
This command does not function in standalone mode.
Enter no qos cos-traffic-class to remove the CoS-to-Traffic Class mapping.
Examples To apply a CoS-to-Traffic Class QoS map named test to a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# qos cos-traffic-class test
To remove CoS-to-Traffic Class QoS mapping from a specific port-channel interface:
switch(config)# interface port-channel 22
switch(config-port-channel-22)# no qos cos-traffic-class
See Also interface, qos cos-mutation, qos map cos-traffic-class, qos trust cos, show qos maps