Brocade Network OS Command Reference v4.1.0 - Manual (Page 452)

414 Network OS Command Reference
53-1003115-01
lacp timeout
2
lacp timeout
Sets the timeout value used by the Link Aggregation Control Protocol (LACP) to exchange packets
on an interface before invalidating a received data unit (DU).
Synopsis lacp timeout {long | short}
no lacp timeout
Operands
long Specifies that a long-timeout value of 30 seconds will be used. With this
value, the port waits three times this long (90 seconds) before invalidating
the information received earlier on this PDU.
short Specifies that a short-timeout value of one second will be used. With this
value, the port waits three times this long (three seconds) before
invalidating the information received earlier on this PDU.
Defaults For Brocade trunks, the default value is the short timeout.
For standard LAGs, the default value is the long timeout.
Command Modes Interface subtype configuration mode
Description Use this command to set the timeout value based on how frequently you think the switch will
receive LACP PDUs from the partner switch.
Usage Guidelines Enter no lacp timeout to return to the default values.
Examples To use the LACP long-timeout value on a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# lacp timeout long
See Also interface