Brocade Network OS Command Reference v4.1.0 - Manual (Page 585)

Network OS Command Reference 547
53-1003115-01
port-profile-port
2
port-profile-port
Activates the Automatic Migration of Port Profiles (AMPP) port-profile configuration mode on a
port.
Synopsis port-profile-port [profile port-profile-name | domain port-profile-domain-name]
no port-profile-port [profile port-profile-name | domain port-profile-domain-name]
Operands profile Selects a port-profile.
port-profile-name Name of a port-profile.
domain Selects a port-profile domain.
port-profile-domain-name
Name of a port-profile domain.
Defaults When neither a profile nor a domain option is used, the port-profiles in default profile domain is
used.
Command Modes Interface subtype configuration mode
Description Use this command to activate AMPP port-profile configuration mode on a specific port. AMPP
management allows you to associate AMPP port-profiles with VMware port groups, and provides a
port-profile comparison tool to easily compare port-profiles within or across fabrics for robust VM
migration.
In a Virtual Fabrics context, use this command with the profile or domain options to associate a
profiled port or a port-profile domain or to a port-profile. The result is that all service or transport
VFs (VLAN ID > 4095) so specified are configured on the port.
Usage Guidelines Enter the no port-profile-port and no shutdown commands to remove the complete AMPP
configuration from the selected port.
Enter no port-profile-port profile port-profile-name or no port-profile-port domain
port-profile-domain-name to dissociate the profiled port from the port-profile or the port-profile
domain, respectively.
When the port-profile-port command is issued without a keyword, the domain referred to is
identified by “default.” The default domain is automatically created by the system during a
firmware upgrade from releases prior to NOS release 4.1.0. When the upgrade is complete, this
domain contains the set of port-profiles that were created before the upgrade.
NOTE
In VF-enabled mode only, the user can manage port-profiles in a default domain as in any other
domain.
Examples The following examples illustrate activating AMPP port-profile configuration mode on a specific
10-gigabit Ethernet interface port.
To associate the default port-profile domain to an interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# port-profile-port
To associate a profiled port with the default port-profile domain:
switch(config)# interface tengigabitethernet 178/0/9