Brocade Network OS Command Reference v4.1.0 - Manual (Page 1068)

1030 Network OS Command Reference
53-1003115-01
show running-config interface fortygigabitethernet sflow
2
show running-config interface fortygigabitethernet sflow
Displays the sFlow configuration for a 40-gigabit Ethernet interface.
Synopsis show running-config interface fortygigabitethernet [rbridge-id/slot/port] sflow [enable |
polling-interval | sample-rate]
Operands rbridge-id Specifies a switch by its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
enable Displays whether sFlow is enabled for the port.
polling-interval Displays the configured maximum number of seconds between successive
samples of counters to be sent to the collector.
sample-rate Displays the number of packets that are skipped before the next sample is
taken for the interface.
Defaults Displays all sFlow configuration information for the port.
Command Modes Privileged EXEC mode
Description Use this command to display the sFlow configuration for the specified interface.
Usage Guidelines None
Examples
switch# show running-config interface fortygigabitethernet 1/0/53 sflow
interface fortygigabitethernet 1/0/53
sflow enable
sflow polling-interval 10
sflow sample-rate 100
See Also sflow enable (interface version), sflow polling-interval (interface version),
sflow sample-rate (interface version)