Brocade Network OS Command Reference v4.1.0 - Manual (Page 423)

Network OS Command Reference 385
53-1003115-01
ip ospf priority
2
ip ospf priority
Configures priority for designated router (DR) election.
Synopsis ip ospf priority value
no ip ospf priority
Operands value Priority value. Valid values range from 0 through 255.
Defaults The default value is 1.
Command Modes Interface subtype configuration mode
Description Use this command to set priority for DR election and backup-router election on the interface you
are connected to. The OSPF router assigned the highest priority becomes the designated router,
and the OSPF router with the second-highest priority becomes the backup router.
Usage Guidelines Enter no ip ospf priority to use the default value.
Examples To set a priority of 10 for the OSPF router that is connected to an OSPF 10-gigabit Ethernet
interface 190/0/49:
switch(config)# interface tengigabitethernet 190/0/49
switch(conf-if-te-190/0/49)# ip ospf priority 10
To set a priority of 10 for the OSPF router that is connected to an OSPF virtual Ethernet (VE)
interface 24:
switch(config)# rbridge-id 178
switch(config-rbridge-id-178)# interface ve 24
switch(config-ve-24)# ip ospf priority 10
See Also interface, interface ve, ip ospf area, ip ospf auth-change-wait-time, ip ospf authentication-key,
ip ospf cost, ip ospf database-filter, ip ospf dead-interval, ip ospf hello-interval,
ip ospf md5-authentication, ip ospf mtu-ignore, ip ospf network, ip ospf passive,
ip ospf retransmit-interval, ip ospf transmit-delay