Brocade Network OS Command Reference v4.1.0 - Manual (Page 290)

252 Network OS Command Reference
53-1003115-01
eir
2
eir
Optional command for configuring the excess information rate for a class-map.
Synopsis eir eir-rate
no eir eir-rate
Operands eir-rate Excess information rate. Valid values range from 0
through 40000000000 bps in multiples of 40000.
Defaults None
Command Modes Policy-map class police configuration mode
Description This command configures the excess information rate for a class-map.
Usage Guidelines Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples This example configures a class-map called “default” within a policy-map.
switch# configure terminal
switch(config)# policy-map policymap1
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch(config-policymap-class-police)# eir 800000
See Also cbs,conform-set-dscp, conform-set-prec, conform-set-tc, ebs, exceed-set-dscp, exceed-set-dscp,
exceed-set-tc, police cir, police-priority-map, policy-map, qos cos, service-policy, set-priority