Brocade Network OS Command Reference v4.1.0 - Manual (Page 394)

356 Network OS Command Reference
53-1003115-01
ip igmp last-member-query-interval
2
ip igmp last-member-query-interval
Sets the last member query interval.
Synopsis ip igmp last-member-query-interval milliseconds
no ip igmp last-member-query-interval
Operands milliseconds Response time in milliseconds. Valid values range from 100
through 25500 milliseconds.
Defaults 1000 milliseconds
Command Modes VE interface configuration mode
VLAN interface configuration mode
Router interface configuration mode
Description Use this command to set the last-member query interval on a specific interface. The last-member
query interval is the time in seconds that the IGMP router waits to receive a response to a
group-specific query message, including messages sent in response to a host-leave message.
Usage Guidelines Enter no ip igmp last-member-query-interval to remove the last-member query interval on a
specific interface.
Examples To set the last-member query interval to 1500 milliseconds on a specific VLAN interface:
switch(config)# interface vlan 100
switch(conf-Vlan-100)# ip igmp last-member-query-interval 1500
See Also interface, interface ve, ip igmp query-interval, ip igmp query-max-response-time,
ip igmp static-group