Brocade Network OS Command Reference v4.1.0 - Manual (Page 171)

Network OS Command Reference 133
53-1003115-01
clear logging raslog
2
clear logging raslog
Clears RASLog messages from the switch.
Synopsis clear logging raslog [message-type {DCE | SYSTEM}] [rbridge-id {rbridge-id | all}]
Operands message-type Clears RASLog messages of the specified type.
SYSTEM Clears system messages.
DCE Clears DCE application messages.
rbridge-id Enables RBridge ID mode to support VCS on individual nodes.
rbridge-id Specifies a unique identifier for a node.
all Specifies all identifiers for a node.
Defaults Clear all RASLog messages of on the local switch.
Command Modes Privileged EXEC mode
Description Use this command to clear the saved RASLog messages.
Usage Guidelines This command is supported only on the local switch.
The rbridge-id operand is supported in VCS mode only.
This command is not supported on the standby management module.
Examples To clear all RASLog messages on the local switch:
switch# clear logging raslog
DCE Raslogs are cleared
SYSTEM Raslogs are cleared
To clear all DCE messages on the local switch:
switch# clear logging raslog message-type DCE
DCE Raslogs are cleared
To clear all SYSTEM messages on the local switch:
switch# clear logging raslog message-type SYSTEM
SYSTEM Raslogs are cleared
See Also logging raslog console, show logging raslog, show running-config logging