Brocade Network OS Command Reference v4.1.0 - Manual (Page 574)

536 Network OS Command Reference
53-1003115-01
pg
2
pg
Creates an N_Port group in Access Gateway mode.
Synopsis pg pgid
no pg pgid
Operands pgid Port group identifier.
Defaults None
Command Modes Access Gateway (AG) configuration
Description Use this command to configure a port group with a unique ID (pgid). Once configured, you can
access the port group in Port Grouping configuration mode to perform configuration tasks, such as
adding and removing N_Ports, enabling port group modes, and renaming the group.
Usage Guidelines You must be in Access Gateway (AG) mode to use this command. The pgid cannot exceed 64
characters.
Examples The following command creates port group 1 and enables Port Grouping configuration mode for
the port group.
sw0(config-rbridge-id-3-ag)# pg 1
sw0(config-rbridge-id-3-ag-pg-1)#
The following command removes port group 1.
sw0(config-rbridge-id-3-ag)# no pg 1
See Also show ag pg