Brocade Network OS Command Reference v4.1.0 - Manual (Page 373)

Network OS Command Reference 335
53-1003115-01
interface management
2
Examples
To configure a management interface with an IPv6 IP address:
switch(config)# interface management 1/0
switch(config-Management-1/0)# ipv6 address \
fd00:60:69bc:832:e61f:13ff:fe67:4b94/64
To set the interface to 100 Mbps Full Duplex
switch(config-Management-1/0)# speed 100
To apply an ACL to the management interfaces on a Brocade VDX 8770-4:
switch(config)# interface Management 1/1
switch(config-Management-1/1)# ip access-group stdACL3 in
switch(config-Management-1/1)# ipv6 access-group stdV6ACL1 in
switch(config-Management-1/1)# exit
switch(config)# interface Management 1/2
switch(config-Management-1/2)# ip access-group extdACL5 in
switch(config-Management-1/2)# exit
To enable DHCP for IPv4 addresses:
switch(config)# interface Management 1/1
switch(config-Management-1/1)# ip address dhcp
To enable DHCP for IPv6 addresses:
switch(config)# interface Management 1/1
switch(config-Management-1/1)# ipv6 address dhcp
Applying an ACL on management interface 1/1:
switch(config)# interface management
switch(config)# interface management 1/1
Entering configuration mode terminal
switch(config-Management-1/1)# ip access-group stdACL1 in
See Also interface, show interface management, show running-config interface management