Brocade Network OS Command Reference v4.1.0 - Manual (Page 178)

140 Network OS Command Reference
53-1003115-01
clear spanning-tree counter
2
clear spanning-tree counter
Clears all spanning-tree counters on the interface.
Synopsis clear spanning-tree counter [interface | port-channel number |
fortygigabitethernet rbridge-id/slot/port | tengigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port]
Operands interface Specifies the interface on which to clear the spanning-tree counters.
port-channel number Specifies the interface is a port-channel. The number of available channels
range from 1 through 63 for standalone mode, and from 1 through 6144
for Brocade VCS Fabric mode. However, the channel can be assigned any
number from 1 through 6144.
fortygigabitethernet rbridge-id/slot/port
Specifies a valid 40-gigabit Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to clear the spanning-tree counters on the interface.
Usage Guidelines If the interface parameter is not specified, spanning-tree counters are cleared for all interfaces.
If xSTP is enabled over VCS, this command must be executed on all RBridge nodes.
Examples To clear spanning-tree counters for all interfaces:
switch# clear spanning-tree counter
To clear spanning-tree counters for a 10-gigabit Ethernet interface:
switch# clear spanning-tree counter interface tengigabitethernet 0/1
To clear spanning-tree counters for port-channel 23:
switch# clear spanning-tree counter interface port-channel 23
See Also show spanning-tree