Brocade Network OS Command Reference v4.1.0 - Manual (Page 751)

Network OS Command Reference 713
53-1003115-01
show dadstatus
2
show dadstatus
Displays the current DHCP auto-deployment (DAD) status output on the switch.
Synopsis show dadstatus
Operands None
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display the DAD status output on the switch.
Usage Guidelines If DAD fails, one of the following errors will show in the output:
1. DHCP auto-deployment failed during DHCP process
2. DHCP auto-deployment failed in sanity check
3. DHCP auto-deployment failed due to same firmware
4. DHCP auto-deployment failed to start firmware download
5. DHCP auto-deployment failed due to firmware download failure
Examples To display DAD status output on the switch:
sw0# show dadstatus
[1] : Thu Aug 15 23:22:50 GMT 2013
DHCP Auto-deployment enabled
[2] : Thu Aug 15 23:27:20 GMT 2013
DHCP Auto-deployment started firmwaredownload
[3] : Thu Aug 15 23:38:57 GMT 2013
DHCP Auto-deployment succeeded
sw0# show dadstatus
[1] : Fri Aug 16 12:02:44 GMT 2013
DHCP Auto-deployment enabled
[2] : Fri Aug 16 12:10:03 GMT 2013
DHCP Auto-deployment failed in sanity check.
See Also firmware download, firmware download logical-chassis, dhcp auto-deployment enable