Brocade Network OS Command Reference v4.1.0 - Manual (Page 79)

Network OS Command Reference 41
53-1003115-01
area stub (OSPF)
2
area stub (OSPF)
Creates a stub area or modifies its parameters.
Synopsis area {A.B.C.D | decimal} stub metric [no-summary]
no area stub
Operands A.B.C.D Area address in dotted decimal format.
decimal Area address In decimal Format.
metric Additional cost for using a route to or from this area.
no-summary When configured on the ABR, prevents any Type 3 and Type 4 summary
LSAs from being injected into the area. The only exception is that a default
route is injected into the stub/totally stubby area by the ABR as a Type 3
LSA. Enabling this parameter makes the area a so-called totally stubby
area, which can only have Types 1 and 2. This parameter is disabled by
default.
Defaults No areas are created.
Command Modes OSPF VRF router configuration mode
Description Use this command to create or delete a stub area or modify its parameters.
Once created, the type of the area cannot be changed. The only exception to this rule is that an
NSSA or stub area can be changed to a totally NSSA or a totally stub area, respectively.
Usage Guidelines Enter no area stub to delete a stub area.
Examples To set an additional cost of jj5 on a stub area called 2 (in decimal format):
switch# configure
switch(config)# rbridge-id 5
switch(config-rbridge-id-5)#router ospf
switch(config-router-ospf-vrf-default-vrf)# area 2 stub 5
See Also None