Brocade Network OS Command Reference v4.1.0 - Manual (Page 577)

Network OS Command Reference 539
53-1003115-01
police cir
2
police cir
Mandatory command for configuring the committed information rate for a class-map.
Synopsis police cir cir-rate
no police cir
Operands cir-rate Committed information rate. Valid values range from 40000
through 40000000000 bps in multiples of 40000.
Defaults None
Command Modes Policy-map class configuration mode
Description This command sets the committed information rate for a class-map.
Usage Guidelines When you are in config-policymap-class mode launching the police cir cir-rate command places
the system in config-policymap-class-police mode for the configured class-map. At this point, you
can add or remove additional policing parameters for the class-map.
Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples This example configures a class-map called “default” within a policy-map.
switch# configure terminal
switch(config)# policy-map policymap1
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch(config-policymap-class-police)#
See Also cbs, conform-set-dscp, conform-set-prec, conform-set-tc, ebs, eir, exceed-set-dscp,
exceed-set-prec, exceed-set-tc, police-priority-map, policy-map, qos cos, service-policy, set-priority