Brocade Network OS Command Reference v4.1.0 - Manual (Page 645)

Network OS Command Reference 607
53-1003115-01
rbridge-id
2
rbridge-id
Enables RBridge ID configuration mode to support VCS on individual nodes.
Synopsis rbridge-id rbridge-id
no rbridge-id rbridge-id
Operands rbridge-id The number of an RBridge node.
Defaults None
Command Modes Global configuration mode
Description Use this command to enter RBridge ID configuration mode for fabric cluster and logical chassis
cluster configuration.
Usage Guidelines
CAUTION
It is always preferable to have the RBridge ID configured on a switch. If the RBridge ID is not
configured, deleting the interface IP address that matches the router ID will cause an OSPF
process reset and a spike in CPU usage.
Examples Use the rbridge-id ? command in global configuration mode to see available nodes.
Enter RBridge ID configuration mode and use ? to view commands available in that mode:
sw0(config)# rbridge-id 154
sw0(config-rbridge-id-154)# ?
Possible completions:
arp Address Resolution Protocol (ARP)
chassis
do Run an operational-mode command
exit Exit from current mode
fabric Allows to configure fabric related parameters
fcsp FCSP configuration commands
filter-change-update-delay Change filter change update delay timer
help Provide help information
interface Interface configuration
ip Configure Internet Protocol (IP)
ipv6 Configure Internet Protocol (IPv6)
logical-chassis Logical chassis commands
management The list of management interfaces.
no Negate a command or set its defaults
protocol Protocol configuration
pwd Display current mode path
route-map Configure a route-map instance
router Configure router
secpolicy Security policy related configuration
ssh Configure SSH Server
switch-attributes Switch attributes configurations
system-monitor Configure FRU threshold and alert setting
telnet Configure Telnet Server
threshold-monitor Configure Class monitoring threshold and alert