Zoning enabled-configuration default-zone-access – Brocade Network OS Command Reference v4.1.0 User Manual

Page 1417

Network OS Command Reference

1379

53-1003115-01

zoning enabled-configuration default-zone-access

Sets the default zone access mode.

Synopsis

zoning enabled-configuration default-zone-access {allaccess | noaccess}

Operands

allaccess

Sets the default zone access mode to “All Access”. Each device can access
all other devices attached to the VCS Fabric.

noaccess

Sets the default zone access mode to “No Access”. No device can access
any other device in the VCS Fabric.

Defaults

Zone access mode is “All Access”.

Command Modes

Global configuration mode

Description

Use this command to display or set the default zone access mode.

Usage Guidelines

This command is supported only in Brocade VCS Fabric mode. Zoning configuration data are
automatically distributed among all RBridges in the VCS Fabric. Standalone mode is not
supported.

This command can be entered on any RBridge in a Brocade VCS Fabric, but it is always executed
on the principal RBridge in fabric cluster mode. In logical chassis cluster mode, edits can be
performed only from the principal RBridge.

ATTENTION

Setting the default zone mode initializes a zoning transaction (if one is not already in progress), and
creates reserved zoning objects. For the change to become effective, you must commit the
transaction with either the zoning enabled-configuration cfg-action cfg-save command or the
zoning enabled-configuration cfg-name command.

NOTE

A default zone controls the device access that is in effect when zoning is not enabled. When a
user-specified zoning configuration is not enabled, the default zone is in effect, allowing access to
all devices or no devices. When a user-specified zone configuration is enabled, it overrides the
default zone access mode.

Examples

To set the default zone mode to All Access:

switch(config)# zoning enabled-configuration default-zone-access allaccess