Show diag status – Brocade Network OS Command Reference v4.1.0 User Manual

Page 775

Network OS Command Reference

737

53-1003115-01

show diag status

Displays the currently diagnostic test status on one or all slots in the system.

Synopsis

show diag status [rbridge-id rbridge-id] [slot slot-id]

Operands

rbridge-idrbridge-id

Specifies the RBridge ID of the switch to display.

slot slot_id

Specifies the slot ID. This is mandatory for slot-based systems only.

Defaults

If an RBridge ID is not specified, diagnostic tests for all blades in the system are displayed.

Command Modes

Privileged EXEC mode

Description

Use this command to display currently running diagnostic tests on a specified switch.

Usage Guidelines

None

Examples

To automatically display current diagnostic status in the console:

switch# show diag status rbridge-id 1

Slot M2 [2]: DIAG runs 'NONE'

Slot S1 [3]: DIAG runs 'NONE'

Slot S2 [4]: DIAG runs 'NONE'

Slot S3 [5]: DIAG runs 'NONE'

Slot L4 [10]: DIAG runs 'NONE'

rbridgeId 1

To display the diagnostic status when POST is running on the LC or SFM using the slot ID:

switch# show diag status rbridge-id 233 slot L1

Slot L1 [7]:DIAG runs ‘turboramtest’

rbridgeId 233

switch# show diag status slot L1

Slot L1 [7]: DIAG runs ‘turboramtest’

rbridgeID 233