Brocade Network OS Command Reference v4.1.0 - Manual (Page 669)

Network OS Command Reference 631
53-1003115-01
route-map
2
route-map
Creates or deletes a route map instance, with a variety of options.
Synopsis route-map name [permit | deny] instance_number | [continue sequence number]
no route-map name [permit | deny] instance_number| [continue sequence number]
Operands name The name of the route map. The string must be between 1 and 63 ASCII
characters in length.
permit Allows a matching pattern
deny Disallows a matching pattern.
instance_number The instance ID. The range is from 1 through 65535.
continue Use a “continue” clause to allow for more programmable policy
configuration and route filtering, with capability to execute additional
entries in a route map after an entry is executed with successful “match”
and “set” clauses.
sequence_number
The sequence ID. The range is from 1 through 65535.
Defaults None
Command Modes RBridge ID configuration mode
Description Use this command to create or delete a route map instance.
This command is used in conjunction with other commands.
For details on match commands, refer to the following commands:
• match (route map)
• match access-list
• match as-path
• match community
• match interface
• match ip address
• match ip next-hop
• match metric
• match protocol bgp
• match route-type
• match tag
For details on set commands, refer to the following commands:
• set as-path
• set as-path prepend
• set automatic-tag
• set comm-list