Brocade Network OS Command Reference v4.1.0 - Manual (Page 410)

372 Network OS Command Reference
53-1003115-01
ip ospf area
2
ip ospf area
Enables OSPF on an interface.
Synopsis ip ospf area area-id
no ip ospf area
Operands area-id Area address in dotted decimal or decimal format.
Defaults OSPF is disabled.
Command Modes Interface subtype configuration mode
Description Use this command to enable an OSPF area on the interface to which you are connected.
Usage Guidelines Enter no ip ospf area to disable OSPF on this interface.
Examples To enable a configured OSPF area named 0 on a specific OSPF 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 190/0/49
switch(conf-if-te-190/0/49)# ip ospf area 0
To enable a configured OSPF area named 0 on a specific OSPF virtual Ethernet (VE) interface:
switch(config)# rbridge-id 178
switch(config-rbridge-id-178)# interface ve 12
switch(config-ve-12)# ip ospf area 0
See Also interface, interface ve, ip ospf auth-change-wait-time, ip ospf authentication-key, ip ospf cost,
ip ospf database-filter, ip ospf dead-interval, ip ospf hello-interval, ip ospf md5-authentication,
ip ospf mtu-ignore, ip ospf network, ip ospf passive, ip ospf priority, ip ospf retransmit-interval,
ip ospf transmit-delay