Brocade Network OS Command Reference v4.1.0 - Manual (Page 76)

38 Network OS Command Reference
53-1003115-01
always-propagate (BGP)
2
always-propagate (BGP)
Enables the device to reflect routes even though they are not installed in the Routing Table
Manager (RTM).
Synopsis always-propagate
no always-propagate
Operands None
Defaults This feature is disabled.
Command Modes BGP address-family IPv4 unicast configuration mode
Description Use this command to enable the device to reflect routes even though they are not installed in the
RTM.
Usage Guidelines Use the no form of this command to restore the default.
Examples To configure the device to reflect routes that are not installed in the RTM:
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# always-propagate
See Also None