Brocade Network OS Command Reference v4.1.0 - Manual (Page 580)

542 Network OS Command Reference
53-1003115-01
port-channel path-cost
2
port-channel path-cost
Sets the path-cost behavior.
Synopsis port-channel path-cost [custom | standard]
Operands custom Specifies to use the custom behavior, which sets the path-cost changes
according to the port-channel’s bandwidth.
standard Specifies to use the standard behavior, which sets that the path-cost does
not change according to port-channel’s bandwidth.
Defaults Path-cost is standard.
Command Modes Protocol Spanning Tree configuration mode
Description Use this command to set the path-cost behavior for the port-channel.
Usage Guidelines If xSTP is enabled over VCS, this command must be executed on all RBridges.
Examples To set the behavior for the path-cost to custom:
switch(conf-mstp)# port-channel path-cost custom
To set the behavior for the path-cost to standard:
switch(conf-mstp)# port-channel path-cost standard
See Also None