Brocade Network OS Command Reference v4.1.0 - Manual (Page 1074)

1036 Network OS Command Reference
53-1003115-01
show running-config interface gigabitethernet bpdu-drop
2
show running-config interface gigabitethernet bpdu-drop
Displays the BPDU drop status of a 1-gigabit Ethernet interface.
Synopsis show running-config interface gigabitethernet [rbridge-id/slot/port] bpdu-drop [enable]
Operands rbridge-id Specifies a switch by its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
enable Displays the drop status of STP/MSTP/RSTP and PVST+/R-PVST+ BPDUs.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display information about dropped BPDUs on the specified Ethernet
interface.
Usage Guidelines STP, RSTP, or MSTP must be configured.
This command can be used only on Brocade VDX 6710, Brocade VDX 8770-4, and
Brocade VDX 8770-8 switches.
Brocade Network OS v4.1.0 supports PVST+ and R-PVST+only. The PVST and R-PVST protocols are
proprietary to Cisco and are not supported.
Examples To display BPDU drop status information for a specific 1-gigabit Ethernet port:
switch# show running-config interface gigabitethernet 1/0/7 bpdu-drop
See Also interface