Brocade Network OS Command Reference v4.1.0 - Manual (Page 57)

Network OS Command Reference 19
53-1003115-01
address-family ipv4 unicast (BGP)
2
address-family ipv4 unicast (BGP)
Enables IPv4 address-family support for BGP4 routing.
Synopsis address-family {ipv4} {unicast}
no address-family {ipv4} {unicast}
Operands None
Defaults None
Command Modes BGP configuration mode
Description Use this command to enter IPv4 address-family configuration mode to configure a variety of BGP4
unicast routing options.
Usage Guidelines Use the no form of this command to remove IPv4 address-family configurations from the device.
Examples To enable BGP IPv4 address-family configuration mode:
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)#
See Also None