beautypg.com

Spanning-tree autoedge – Brocade Network OS Command Reference v4.1.0 User Manual

Page 1274

background image

1236

Network OS Command Reference

53-1003115-01

spanning-tree autoedge

2

spanning-tree autoedge

Enables automatic edge detection.

Synopsis

spanning-tree autoedge

no spanning-tree autoedge

Operands

None

Defaults

Auto-detection is not enabled.

Command Modes

Interface subtype configuration mode

Description

Use this command to automatically identify the edge port.

Usage Guidelines

The port can become an edge port if no Bridge Protocol Data Unit (BPDU) is received.

If xSTP is enabled over VCS, this command must be executed on all the RBridge nodes.Enter
no spanning-tree autoedge to disable automatic edge detection.

Examples

To enable automatic edge detection:

switch(config)# interface tengigabitethernet 0/1

switch(conf-if-te-0/1)# spanning-tree autoedge

See Also

protocol spanning-tree