Dot1x timeout server-timeout, Dot1x timeout server-timeout, do, T1x timeout server-timeout, do – Brocade Network OS Command Reference v4.1.0 User Manual
Page 282
244
Network OS Command Reference
53-1003115-01
dot1x timeout server-timeout
2
dot1x timeout server-timeout
Sets the 802.1X authentication-sever response timeout.
Synopsis
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
Operands
seconds
Specifies the number of seconds that a switch waits for the response from
the 802.1X authentication server. Valid values range from 1
through 65535.
Defaults
30 seconds
Command Modes
Interface subtype configuration mode
Description
Use this command to set the authentication sever response timeout for a specific interface.
Usage Guidelines
Enter no dot1x timeout server-timeout to return to the default setting.
Examples
To set 40 seconds as the switch-to-authentication server transmission time on a specific
10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# dot1x timeout server-timeout 40
To set the switch-to-authentication server transmission time to the default value on a specific
1-gigabit Ethernet interface:
switch(config)# interface gigabitethernet 170/4/2
switch(conf-if-gi-170/4/2)# no dot1x timeout server-timeout
See Also
interface, dot1x timeout re-authperiod, dot1x timeout supp-timeout, dot1x timeout tx-period