Brocade Network OS Command Reference v4.1.0 - Manual (Page 283)

Network OS Command Reference 245
53-1003115-01
dot1x timeout supp-timeout
2
dot1x timeout supp-timeout
Specifies the EAP response timeout for 802.1X authentication.
Synopsis dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Operands seconds Specifies the number of seconds that the switch waits for a response to the
EAP frame. Valid values range from 1 through 65535.
Defaults 30 seconds
Command Modes Interface subtype configuration mode
Description Use this command to set the time in seconds that a switch waits for a response to an Extensible
Authentication Protocol (EAP) request frame from the client before resending the request.
Usage Guidelines Enter no dot1x timeout supp-timeout to return to the default setting.
Examples To set 45 seconds as the switch-to-client retransmission time for the EAP request frame on a
specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/8
switch(conf-if-te-178/0/8)# dot1x timeout supp-timeout 45
To set the switch-to-client retransmission time for the EAP request frame to the default value on a
specific 40-gigabit Ethernet interface:
switch(config)# interface fortygigabitethernet 190/0/16
switch(conf-if-fo-190/0/16)# no dot1x timeout supp-timeout
See Also interface, dot1x timeout re-authperiod, dot1x timeout server-timeout, dot1x timeout tx-period