Brocade Network OS Command Reference v4.1.0 - Manual (Page 318)

280 Network OS Command Reference
53-1003115-01
fcoeport
2
fcoeport
Provisions a port with the default FCoE map.
Synopsis fcoeport map
no fcoeport
Operands map This must be default.
Defaults None
Command Modes Interface subtype configuration mode
Description Use this command to configure a specific port to be an FCoE port with the assigned map name
default.
Usage Guidelines The only map name allowed is default.
Enter no fcoeport to remove the FCoE port configuration from the applicable port.
Examples To provision a specific 10-gigabit Ethernet interface port with the default FCoE map:
switch(config)# interface tengigabitethernet 101/0/1
switch(conf-if-te-101/0/1)# fcoeport default
See Also interface