Brocade Network OS Command Reference v4.1.0 - Manual (Page 549)

Network OS Command Reference 511
53-1003115-01
neighbor send-community (BGP)
2
neighbor send-community (BGP)
Enables sending the community attribute in updates to the specified BGP neighbor.
Synopsis neighbor {ip-address | peer-group-name} send-community {both | extended | standard}
no neighbor {ip-address | peer-group-name} send-community {both | extended | standard}
Operands ip-address IPv4 address of the neighbor
peer-group-name Peer group name configured by the neighbor peer-group-name command.
both Sends both standard and extended attributes.
extended Sends extended attributes.
standard Sends standard attributes.
Defaults The device does not send community attributes.
Command Modes BGP address-family IPv4 unicast configuration mode
Description Use this command to send the community attribute in updates to the specified BGP neighbor.
Usage Guidelines Use the no form of the command to restore the defaults.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# neighbor 10.11.12.13 send-community standard
See Also route-map