Brocade Network OS Command Reference v4.1.0 - Manual (Page 708)

670 Network OS Command Reference
53-1003115-01
set-priority
2
set-priority
Optional command for configuring the priority map of a class-map.
Synopsis set-priority priority-map-name
no set-priority priority-map-name
Operands priority-map-nameThe priority-map name that you are including in the policy-map. Refer to the
description of the police-priority-map command.
Defaults None
Command Modes Class-map configuration mode
Description This command configures the priority map of a class-map.
Usage Guidelines Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch (config-policymap-class)# set-priority default
See Also cbs,conform-set-dscp, conform-set-prec, conform-set-tc, ebs, eir, exceed-set-dscp,
exceed-set-prec, exceed-set-tc, police cir, police-priority-map, policy-map, qos cos, service-policy