Brocade Network OS Command Reference v4.1.0 - Manual (Page 425)

Network OS Command Reference 387
53-1003115-01
ip ospf transmit-delay
2
ip ospf transmit-delay
Configures transmit delay for link-update packets.
Synopsis ip ospf transmit-delay tx-delay
no ip ospf transmit-delay
Operands tx-delay Transmit delay in seconds. Valid values range from 0 through
3600 seconds.
Defaults 1 second.
Command Modes Interface subtype configuration mode
Description Use this command to set the estimated time required for OSPF to send link-state update packets
on the interface to which you are connected.
Usage Guidelines Enter no ip ospf transmit-delay to use the default value.
Examples To set a transmit delay of 10 seconds for routers on the OSPF 10-gigabit Ethernet interface
190/0/49:
switch(config)# interface tengigabitethernet 190/0/49
switch(conf-if-te-190/0/49)# ip ospf transmit-delay 10
To set a transmit delay of 30 seconds for routers on the OSPF virtual Ethernet (VE) interface 24:
switch(config)# rbridge-id 178
switch(config-rbridge-id-178)# interface ve 24
switch(config-ve-24)# ip ospf transmit-delay 30
See Also interface, interface ve, ip ospf area, ip ospf auth-change-wait-time, ip ospf authentication-key,
ip ospf cost, ip ospf database-filter, ip ospf dead-interval, ip ospf hello-interval,
ip ospf md5-authentication, ip ospf mtu-ignore, ip ospf network, ip ospf passive, ip ospf priority,
ip ospf retransmit-interval