Redistribute (bgp) – Brocade Network OS Command Reference v4.1.0 User Manual

Page 648

610

Network OS Command Reference

53-1003115-01

redistribute (BGP)

Configures the device to redistribute OSPF, ISIS, or RIP routes, directly connected routes, or static
routes into BGP4.

Synopsis

redistribute {connected | static} [metric num] | route-map string

no redistribute {connected | static} [metric num] | route-map string

Operands

connected

Redistributes connected routes.

static

Redistributes static routes.

The range is from 0 through 4294967297.

string

Specifies a route map to be consulted before an OSPF route is added to the
BGP4 routing table.

Defaults

No value is assigned for num.

Command Modes

BGP address-family IPv4 unicast configuration mode

Description

By default, the device does not redistribute routing information between BGP4 and the IP interior
gateway protocol OSPF. Use this command to configure the device to redistribute OSPF, directly
connected routes, or static routes into BGP4. The routes can be filtered by means of an associated
route map before they are distributed.

Usage Guidelines

Use the no form of the command to restore the defaults.

NOTE

The default-metric command does not apply to the redistribution of directly connected routes into
BGP4. Use a route map to change the default metric for directly connected routes.

Examples

switch(config)# rbridge-id 10

switch(config-rbridge-id-10)# router bgp

switch(config-bgp-router)# address-family ipv4 unicast

switch(config-bgp-ipv4u)# redistribute static metric 200