Brocade Network OS Command Reference v4.1.0 - Manual (Page 718)

680 Network OS Command Reference
53-1003115-01
sflow sample-rate (interface version)
2
sflow sample-rate (interface version)
Sets the default sampling rate for an interface.
Synopsis sflow sample-rate sample rate
no sflow sample-rate
Operands sample rate Specifies the sampling rate. Valid values range from 2 through
16777215 packets.
Defaults The default is 32768.
Command Modes Interface subtype configuration mode
Description Use this command to change the default sampling rate for a specific interface. This determines
how many packets are skipped before the next sample is taken for that interface. The default
sampling rate of an interface is set to the same value as the current global default sampling rate.
Usage Guidelines This command changes the sampling rate for an interface.
Enter no sflow sample-rate to return to the default setting.
Examples To change the sampling rate to 4096 packets on a specific 40-gigabit Ethernet interface:
switch(config)# interface fortygigabitethernet 1/3/1
switch(conf-if-fo-1/3/1)# sflow sample-rate 4096
See Also interface, sflow sample-rate (global version), sflow enable (interface version),
sflow polling-interval (interface version)