Brocade Network OS Command Reference v4.1.0 - Manual (Page 1367)

Network OS Command Reference 1329
53-1003115-01
trunk-enable
2
trunk-enable
Enables trunking on a Fibre Channel port.
Synopsis trunk-enable
no trunk-enable
Operands None
Defaults Trunking is disabled.
Command Modes Interface Fibre Channel configuration mode
Description Use this command to enable trunking on a Fibre Channel port.
Usage Guidelines This command can be used only on Network OS platforms with Fibre Channel ports
(Brocade VDX 6730-32 and Brocade VDX 6730-76 switches), in Brocade VCS Fabric mode, and
with the FCoE license installed.
A long-distance link can also be configured to be part of a trunk group.
While using R_RDY mode flow control, an E_Port cannot form trunk groups of long distance links
even if trunking is enabled.
Enter no trunk-enable to disable trunking on a Fibre Channel port.
Examples To enable trunking mode on a Fibre Channel port:
switch (config)# interface FibreChannel 7/0/2
switch(conf-FibreChannel-7/0/2)# trunk-enable
To disable trunking mode on a Fibre Channel port:
switch (config)# interface FibreChannel 7/0/2
switch(conf-FibreChannel-7/0/2)# no trunk-enable
See Also desire-distance, fill-word, interface, isl-r_rdy, long-distance,
show running-config interface FibreChannel, shutdown, speed (Fibre Channel), vc-link-init