Zoning enabled-configuration cfg-name – Brocade Network OS Command Reference v4.1.0 User Manual

Page 1416

1378

Network OS Command Reference

53-1003115-01

zoning enabled-configuration cfg-name

Enables a zone configuration.

Synopsis

zoning enabled-configuration cfg-name cfgName

no zoning enabled-configuration cfg-name

Operands

cfgName

Specifies the configuration to be enabled.

Defaults

Zoning is not implemented and default zoning applies.

Command Modes

Global configuration mode

Description

Use this command to enable a specific configuration. This command commits the current defined
zone configuration to both volatile and nonvolatile memory.

Usage Guidelines

Only one configuration can be enabled at a time.

This command is supported only in Brocade VCS Fabric mode. Zoning configuration data are
automatically distributed among all RBridges in the VCS Fabric. Standalone mode is not
supported.

This command can be entered on any RBridge in a Brocade VCS Fabric, but it is always executed
on the principal RBridge in fabric cluster mode. In logical chassis cluster mode, edits can be
performed only from the principal RBridge.

If the operation fails, the previous state is preserved; that is, zoning remains disabled, or the
previous effective configuration remains in effect. If the operation succeeds, the new configuration
replaces the previous effective configuration.

Enter no zoning enabled-configuration cfg-name to disable the currently enabled configuration.
The VCS Fabric returns to default zoning mode. In this mode, either all devices can access one
another, or no device can access any other device, depending on if the default zoning mode is
ALLACCESS or NOACCESS.

NOTE

If more than 300 devices are connected when the enabled-configuration is disabled, the no zoning
enabled-configuration cfg-name command is not allowed if the defzone mode is AllAccess. In this
case, change the defzone mode to No Access and then disable the enabled-configuration.

Examples

To enable a zone configuration:

switch(config)# zoning enabled-configuration cfg-name myconfig

To disable the currently enabled configuration:

switch(config)# no zoning enabled-configuration cfg-name