Brocade Network OS Command Reference v4.1.0 - Manual (Page 272)

234 Network OS Command Reference
53-1003115-01
dot1x authentication
2
dot1x authentication
Enables 802.1Xauthentication on a port.
Synopsis dot1x authentication
no dot1x authentication
Operands None
Defaults 802.1Xauthentication is disabled for ports.
Command Modes Interface subtype configuration mode
Description Use this command to enable 802.1Xauthentication on a specific port.
Usage Guidelines Enter no dot1x authentication to disable dot1x on the port and remove the configuration from
802.1X management.
Examples To enable 802.1Xauthentication on a specific 10-gigabit Ethernet interface port:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# dot1x authentication
To disable 802.1Xauthentication on a specific 40-gigabit Ethernet interface port and remove the
configuration from 802.1X management:
switch(config)# interface fortygigabitethernet 180/0/6
switch(conf-if-fo-180/0/6)# no dot1x authentication
See Also interface, dot1x port-control, dot1x quiet-period, dot1x reauthentication, dot1x reauthMax,
dot1x timeout re-authperiod, dot1x timeout server-timeout, dot1x timeout supp-timeout,
dot1x timeout tx-period