Brocade Network OS Command Reference v4.1.0 - Manual (Page 557)

Network OS Command Reference 519
53-1003115-01
network (BGP)
2
network (BGP)
Configures the device to advertise a network.
Synopsis network network/mask [route-map map-name] | [weight num] | [backdoor]
no network network/mask [route-map map-name] | [weight num] | [backdoor]
Operands network/mask Network and mask in CIDR notation.
map-name Name of the route map with which to set or change BGP4 attributes for the
network to be advertised.
num Weight to be added to routes to this network. Range is 0 through 65535.
backdoor Changes administrative distance of the route to this network from the EBGP
administrative distance (the default is 20) to the local BGP4 weight (the
default is 200), tagging the route as a backdoor route.
Defaults The default for num is 0.
Command Modes BGP address-family IPv4 unicast configuration mode
Description Use this command to configure the device to advertise a network. BGP4 prefers larger weights
over smaller weights.
Usage Guidelines Use the no form of the command to restore the defaults.
Examples
switch(config)# rbridge-id 10
switch(config-rbridge-id-10)# router bgp
switch(config-bgp-router)# address-family ipv4 unicast
switch(config-bgp-ipv4u)# network 10.11.12.13/30 route-map myroutemap
See Also route-map