Brocade Network OS Command Reference v4.1.0 - Manual (Page 432)

394 Network OS Command Reference
53-1003115-01
ip route
2
slot Specifies a valid slot number.
port Specifies a valid port number.
metric Cost metric of the route. Valid values range from 1through 16. The default
is 1.
distance distance Specifies the administrative distance of the route. When comparing
otherwise equal routes to a destination, a Brocade device prefers lower
administrative distances over higher ones. Valid values range from 1
through 255. The default is 1.
tag tag Tag value of the route to use for route filtering with a route map. Valid
values range from 0through 4294967295.
Defaults Refer to the Operands descriptions for specific defaults.
Command Modes RBridge ID configuration mode
Description Use this command to add a route to the IP routing tables.
Usage Guidelines Enter no ip route followed by the route identifier to remove a static route.
On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows:
• On Brocade VDX 8770 switches: 1 through 4086 for 802.1Q VLANs (VLAN IDs 4087
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
• On all other Brocade VDX switches: 1 through 3962 for 802.1Q VLANs (VLAN IDs 3963
through 4095 are reserved on these switches), and 4096 through 8191 for service or
transport VFs in a Virtual Fabrics context.
Examples To configure a static route to 10.95.7.0, using 10.95.6.157 as the next-hop gateway.
switch (config)# rbridge-id 30
switch (config-rbridge-id-30)# ip route 10.95.7.0/24 10.95.6.157
See Also None