Brocade Network OS Command Reference v4.1.0 - Manual (Page 1113)

Network OS Command Reference 1075
53-1003115-01
show running-config interface tengigabitethernet switchport
2
show running-config interface
tengigabitethernet switchport
Displays the configured switching characteristics for the 10-gigabit Ethernet Layer 2 interface.
Synopsis show running-config interface tengigabitethernet [rbridge-id | slot | port ] switchport
[access [vlan] | mode | trunk [allowed [vlan] | native-vlan | tag [native-vlan]]
Operands rbridge-id Specifies a switch by its RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
access Displays whether the Layer 2 interface is configured as access.
access vlan Displays whether the specific VLAN on the Layer 2 interface is configured
as access.
mode Displays whether the Layer 2 interface is configured for access, trunk or
converged.
trunk Displays whether the Layer 2 interface is configured for trunk.
trunk allowed Displays the configuration settings that determine the VLANs that will
transmit and receive through the Layer 2 interface.
trunk allowed vlan Displays the configuration settings for a specific VLAN.
trunk allowed native-vlan
Displays the configured native VLAN characteristics of the Layer 2 trunk
interface for classifying untagged traffic.
trunk tag Displays whether tagging is enabled.
tag native-vlan Displays tags for the native VLAN.
Defaults Displays all configured Layer 2 switching characteristics for the port.
Command Modes Privileged EXEC mode
Description Use this command to display configured switching characteristics for the port.
Usage Guidelines None
Examples
switch# show running-config interface tengigabitethernet 1/0/49 switchport
interface tengigabitethernet 1/0/49
switchport
switchport mode access
switchport access vlan 1
See Also switchport, switchport access, switchport mode, switchport trunk allowed vlan rspan-vlan