Brocade Network OS Command Reference v4.1.0 - Manual (Page 947)

Network OS Command Reference 909
53-1003115-01
show linecard
2
show linecard
Displays information about the interface modules (line cards) present in the chassis.
Synopsis show linecard
Operands None
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display information about the interface modules present in a modular
switch. The output includes the following information:
Slot Displays the slot number. Slots for interface modules are L1 through L4 on
Brocade VDX 8770-4 switches, and L1 through L8 on Brocade VDX 8770-8
switches.
Type Displays the interface module type. Valid types include the following
LC48X10G 48-port 10 GbE interface module (line card)
LC48X1G 48-port 1 GbE interface module (line card)
LC12X40G 12-port 40 GbE interface module
Description Module description
ID IDs for interface modules include the following:
114 48-port 10 GbE interface module
127 12-port 40 GbE interface module
131 48-port 1 GbE interface module
Status Displays the status of the module as one of the following:
VACANT The slot is empty.
POWERED-OFF The module is present in the slot but is powered off.
POWERING UP The module is present and powering on.
LOADING The module is present, powered on, and loading the initial configuration.
DIAG RUNNING POST1
The module is present, powered on, and running the POST (power-on
self-test).
DIAG RUNNING POST2
The module is present, powered on, and running the reboot power on self
tests.
INITIALIZING The module is present, powered on, and initializing hardware components.
ENABLED The module is on and fully enabled.
DISABLED The module is powered on but disabled.
FAULTY The module is faulty because an error was detected.
UNKNOWN The module is inserted but its state cannot be determined.